BALL-TYPE FAUCET REPAIR
Shut off water supply valves then
drain lines by turning faucet on.
Use an allen wrench to loosen the
set screw holding the handle in place and remove
handle.
Loosen and remove the adjusting
ring by using the special wrench provided in the
repair kit.
To remove cap, use pliers and turn
counterclockwise. Protect cap finish with cloth.
Remove spout assembly.
Remove cam assembly by pulling up
on ball shaft. You may need to use pliers.
Removing seats and springs is best
done by inserting a pencil or sharp tool into the
seat assembly and gently lifting it out. Check and
clean inlet ports before replacing seats and
springs.
To replace "O" rings on body, use
a sharp tool to pry away from body. Roll new
correct size "O" ring into place.
When reassembling, be sure to
align slot in ball with pin in body and key on cam
with slot in body.
Hand-tighten the cap, then screw
adjusting ring into place with special wrench and
replace handle. Turn on water and check for leaks.
If necessary, further tighten adjusting ring.
